DNC and CNC setting for Mitsubishi - M50
These settings for DNC Precision software only. It may not work with other software.
Set the following parameters on the machine
| Use different devices for input and output, but with same port number |
IO parameters screen 1/6
| 9001 (In port #) | 2 |
| 9002 (In device #) | 1 |
| 9003 (Out port #) | 2 |
| 9004 (Out device #) | 0 |
| 9005 (Tape mode) | 2 |
|
IO parameters screen 2/6
| Parameter | Value |
| 9101 | OUT/IN |
| 9201 | OUT/IN |
| 9102 (baud rate) | 2 (4800) |
| 9202 (baud rate) | 2 (4800) |
| 9103 (stop bits) | 1 (one stop bit) |
| 9203 (stop bits) | 1 (one stop bit) |
| 9104 (add parity) | 1 (Yes) |
| 9204 (add parity) | 1 (Yes) |
| 9105 (parity) | 1 (Even) |
| 9205 (parity) | 1 (Even) |
| 9106 (data bits) | 2 (7 data bits) |
| 9206 (data bits) | 2 (7 data bits) |
| 9108 (use DC codes) | 3 (yes, DC1 and DC3) |
| 9208 (use DC codes) | 3 (yes, DC1 and DC3) |
| 9109 (no parity for DC codes) | 1 (Yes) |
| 9209 (no parity for DC codes) | 1 (Yes) |
|
|
Set the following parameters on the PC
Serial port tab
| Machine name | Mitsubishi - M50 |
| Serial port | COM2 (or any free COM port) |
| Baud | 4800 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 1 |
Data flow control tab
| Use DTR | False |
| Use RTS | True |
| Require DSR | False |
| Require CTS | True |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | Both |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start:
Program end:
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No |
| Null modem cable, without handshake |
| PC, 9pin, DB9M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, with full handshake |
| PC, 9pin, DB9M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, without handshake |
| PC, 25pin, DB25M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, with full handshake |
| PC, 9pin, DB25M |
CNC, 25pin, DB25 |
|
|
If you have successfully connected DNC Precision
with any other controller not in this list, we would appreciate
your sending us the
details to add to the list.
Note: We are not
responsible and do not provide guarantee for any of these
settings, that have been sent us by our customers.
