DNC and CNC setting for Mazak - T32 M2

These settings for DNC Precision software only. It may not work with other software.

Set the following parameters on the machine

I1 2 I2 3 I3 0 I4 0 I5 3 I6 3 I7 1 I8 5 I9 0 I10 1 I11 1 I12 0 I13 0 I14 0 I15 30 I16 0 I24 0 I58 0000 0000

Set the following parameters on the PC

Serial port tab

Machine name	Mazak - T32 M2
Serial port	COM2 (or any free COM port)
Baud	4800
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	Both
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: Program end: Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Null modem cable, without handshake PC, 9pin, DB9M CNC, 25pin, DB25	Null modem cable, with full handshake PC, 9pin, DB9M CNC, 25pin, DB25
Null modem cable, without handshake PC, 25pin, DB25M CNC, 25pin, DB25	Null modem cable, with full handshake PC, 9pin, DB25M CNC, 25pin, DB25

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.